Security cameras - Closed Circuit Television systems CCTV
Metal Detectors
Electronic Article Surveillance
Tiger Teeth : Traffic Control
Tiger Teeth - Tiger Tooth - Sabre Teeth - Tire Shredders - Bollard Systems and Barricades
Guard Tour
Guard Tour - Guard Tour System - Guard Tour Verification
Counterfeit Detection and Bill Counters
Counterfeit Detection and Bill Counters
Alarms
Burglar Alarms - Wireless Burglar Alarms - Fire Alarms
Audio recorders
Vehicle inspection
Explosive transport
Personal protection
Parking booths
Parking Booths /Security Parking Booths/Guard Booths/Guard Shacks/Kiosks
Asset Management
CES
8245 NW 36th Street
Suite #6
Miami, FL 33166
Phone:
305.499.9396
Fax:
305.499.9636
security@controlelectronic.com
Contáctenos en Español:
seguridad@controlelectronic.com
Disclaimer: All sales are final.
Telephones: (305) 499 9396
(786) 299 1373
Tiger Teeth - Tire Shredders - Saber Tiger Tooth - Parking Security - Parking Control Systems - Parking Equipment - Spike Systems
BUY TIGER TEETH MADE IN U.S.A. FROM MIKE, A PROUD U.S.ARMY VETERAN. CALL HIM AT 305-499-9396
OUR HIGH QUALITY TIGER TEETH SPRINGS ARE MADE BY AMERICANS FOR AMERICANS, DO NOT SURRENDER YOUR OWN SECURITY TO LOW QUALITY, HIGH PRICED, FOREIGN MADE “TIGER” TEETH. REMEMBER: HIGH QUALITY 3´ TIGER TEETH ARE COMPOSED OF THREE ONE FOOT SECTIONS IN ORDER TO PROPERLY BALANCE THE WEIGHT, FOR LASTING DURABILITY.
Traffic Control: Tiger Teeth - Tire Shredders
Tiger Teeth Traffic Controllers enforce "One Way"
traffic flow for parking facilities or other single direction vehicle
lanes.
The torsion spring actuated tiger teeth, positively control traffic in
one direction, while permitting free flow in the other direction. The
teeth will puncture all pneumatic tires, including steel belted radial
and large truck tires.
1- Tiger Teeth Traffic Controllers - Surface Mounted
2- Traffic Controllers - Flush Mounted (Below Ground)
3- Tiger Teeth Traffic Controllers - Motorized - Flush Mounted
4- Tiger Teeth Traffic Controllers - Motorized - Surface Mounted
Tiger teeth:
1- Tiger Teeth Traffic Controllers - Surface Mounted
- Surface mount for rapid installation and speed bump effect.
- 36 inches (914 mm) long x 22 inches (558.8 mm) x 2.0 inches (50.8 mm) high. Overall height 4 inches (101.6 mm).
- Nine electroplated Teeth.
- Long life stainless steel torsion springs.
- All welded steel frame.
- 125 pounds.
- Optional in latch down version.
Surface Mounted Tiger Teeth Drawings
Easily installed on existing roadway - No excavating or asphalt cutting is required - Low profile for smooth passage - Fabricated in 3-ft sections to customize your traffic lane width - All welded construction - 1/4" thick hot rolled steel for "lasting durability"
Tiger Teeth Traffic Controllers - Surface Mounted -
Click Here to Download Tiger Teeth Surface Mounted Drawings
Back to top
Tiger teeth:
2- Traffic Controllers - Flush Mounted (Below Ground)
- Standard Sabre Tooth controller flush installation 3 Feet (1.81 meters) long x 7-1/2 inches (39.4 mm) x 5 inches (127 mm) deep
- 9 electroplated Sabre Teeth
- Long-life torsion springs
- All welded steel frame
- 65 pounds (29 Kg)
- Latch-down option
Flush Mounted (Below Ground) Tiger Teeth Drawings
Easily installed to existing or newly constructed roadway - Minimal excavating to concrete or asphalt is required - Low profile for smooth passage - Fabricated in 3-ft sections to customize your traffic lane width - All welded construction - 1/4" thick hot rolled steel for lasting durability. - All our Tiger Teeth have latch down option
Traffic Controllers - Flush Mounted (Below Ground) -
Click Here to Download Tiger Teeth Below Ground Drawings
Click Here to Download Installation Guideline Tiger Teeth Below Ground
*Call for more details of our Heavy Duty - Latch Down Tiger Teeth: (305) 499 93 96
Back to top
Tiger teeth:
3- Tiger Teeth Traffic Controllers - Motorized - Flush Mounted
Motorized Traffic control products are ideal for controlling most one way traffic. The traffic control spike set will allow vehicular traffic travel in one direction only.
Motorized Tiger Teeth - Flush Mounted (Below Ground)
The Automated / Hydraulic, flush mount traffic controller is designed to regulate the flow of traffic through a secured control point, while providing both a physical and visual barrier to approaching vehicles and preventing against unauthorized vehicles from either entering or exiting a secured control point.
• Hydraulic Control Unit: Provides weather and antivandal protection
• Tunnel Section: Standard 36” inch modules. Can be sized as required.
• Traffic Control Modules: Lengths 36” inches, up to a maximum of 8 modules (24 feet) of control modules can be driven form a single hydraulic control unit .
• Operating Time: Cycle to lower teeth 1 second, Cycle to raise teeth 1 second
• Drive Configuration: Hydraulic power unit.
• Power Requirements: ½ HP, 110V Single-phase 7A. The unit can be built to meet any local power requirement as to voltage, frequency and phase.
• Finish: Epoxy urethane enamel (Red or Yellow)
• Control Circuit: The machine is completely pre-wired requiring only the connection of the power feed and the control circuits. The circuits and power connections are terminated at the wire connector strips in the electrical control box located in the locked hydraulic control cabinet. The controls are pre-wired to accommodate a wide range of control options including: remote open and close from multiple locations; radio open and close; open by card reader, key switch or vehicle detector.
• Documentation: Each machine is furnished with the following, Mechanical Installation Instructions, Electrical & Control Installation, Start Up Procedures, Trouble Shooting, Electrical, Mechanical Drawings
• Options: Stop-Go Signal, Radio Receiver, Remote Radio Control, High Security Card Readers, Key, Battery Backup.
• Shipping Weight: This machine is modularized for ease of shipping and handling.
| Hydraulic Control Cabinet | 175 lbs. |
| Drive Tunnel 36.0 inches | 175 lbs. |
| Control Ramps 36.0 inches | 220 lbs. |
Click Here to Download Tiger Teeth Hydraulic Flush Mounted Specs
Tiger Teeth Traffic Controllers - Motorized - Flush Mounted or surface mounted
*Kit is One Motor, 3 feet of tunnel, plus 6 foot Tiger Teeth, plus one guard button
Tiger teeth:
4- Tiger Teeth Traffic Controllers - Motorized - Surface Mounted
Motorized Tiger Teeth - Surface Mounted
The Automated / Hydraulic, surface mount traffic controller is designed to regulate the flow of traffic through a secured control point, while providing both a physical and visual barrier to approaching vehicles and preventing against unauthorized vehicles from either entering or exiting a secured control point.
• Hydraulic Control Unit: Provides weather and antivandal protection
• Tunnel Section: Standard 36” inch modules. Can be sized as required.
• Traffic Control Modules: Lengths 36” inches, up to a maximum of 8 modules (24 feet) of control modules can be driven form a single hydraulic control unit .
• Operating Time: Cycle to lower teeth 1 second, Cycle to raise teeth 1 second
• Drive Configuration: Hydraulic power unit.
• Power Requirements: ½ HP, 110V Single-phase 7A. The unit can be built to meet any local power requirement as to voltage, frequency and phase.
• Finish: Epoxy urethane enamel (Red or Yellow)
• Control Circuit: The machine is completely pre-wired requiring only the connection of the power feed and the control circuits. The circuits and power connections are terminated at the wire connector strips in the electrical control box located in the locked hydraulic control cabinet. The controls are pre-wired to accommodate a wide range of control options including: remote open and close from multiple locations; radio open and close; open by card reader, key switch or vehicle detector.
• Documentation: Each machine is furnished with the following, Mechanical Installation Instructions, Electrical & Control Installation, Start Up Procedures, Trouble Shooting, Electrical, Mechanical Drawings
• Options: Stop-Go Signal, Radio Receiver, Remote Radio Control, High Security Card Readers, Key, Battery Backup.
• Shipping Weight: This machine is modularized for ease of shipping and handling.
| Hydraulic Control Cabinet | 175 lbs. |
| Drive Tunnel 36.0 inches | 175 lbs. |
| Control Ramps 36.0 inches | 220 lbs. |
Click Here to Download Tiger teeth Motorized Above Ground Specs and graphics
Tiger Teeth Traffic Controllers - Motorized - Flush Mounted or surface mounted
*Kit is One Motor, 3 feet of tunnel, plus 6 foot Tiger Teeth, plus one guard button Back to top
Tiger teeth:
Strongly recommended for motorized Tiger Teeth installations.
*Contact Us for price
Tiger teeth:
Synchronized barrier gate for motorized tiger teeth( when spikes are down the arm is up and vice versa)
*Contact Us for price
Tiger teeth:
 |
|
)
)
White High gloss two part polyurethane industrial finish - Doubled face illuminated polycarbonate signage - Photocell controlled /dusk to dawn - Flood Lamp included for traffic lane safety - 16 Gauge galvanized steel construction - 120 Volt rating
*Contact Us for price
Back to top
Home
-
About
Us -
Product List -
Security
cameras / Closed Circuit Television systems CCTV -
Metal
Detectors -
Electronic
Article Surveillance -Traffic
Coltrol -
Guard
Tour -
Counterfeit
Detection and Bill Counters -
Alarms
-
Audio
Recorders -
Vehicle
Inspection -
Explosive
Transport -
Personal
Protection -
Parking Booths -
Contact
Us